JVC SP-THS55F - Manual (Page 27)

Masterpage:Right+
Filename [TH-R1R3EU_05Name.fm]
Page 24Monday, 28 March 2005 21:23
INITIAL SETTINGS
24
Setting The Crossover Frequency
By setting the crossover frequency, frequencies lower than the
frequency being set is output from the subwoofer.
1
Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2
Press F or G to display ACROSS :B on the front display panel.
3
Press D or E to select the frequency.
Select one of the crossover frequency according to size of the
connected speaker.
Setting The Midnight Mode
You can enjoy powerful sounds at night by setting the midnight
mode.
1
Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2
Press F or G to display ANIGHT :B on the front display panel.
3
Press D or E to select the mode.
Select one of the following modes.
80Hz
Select this when using cone speaker that is about
12 cm.
100Hz
Select this when using cone speaker that is about
10 cm.
120Hz
Select this when using cone speaker that is about
8 cm.
150Hz
Select this when using cone speaker that is about
6 cm. (Default)
200Hz
Select this when using cone speaker that is about
5 cm.
Each time you press D or E, the display changes as follows:
80HzN100HzN120HzN150HzN200HzN (back to the
beginning)
NIGHT : 1
Select this when you want to reduce the
dynamic range slightly.
NIGHT : 2
Select this when you want to maximise the
compression effect. (Ideal for midnight)
NIGHT : OFF
Select this when playing back using full
dynamic range. (Midnight mode not
activated) (Default)
Each time you press D or E, the display changes as follows:
NIGHT : 1NNIGHT : 2NNIGHT : OFFN (back to the beginning)
TH-R1R3EU_00.book Page 24 Monday, March 28, 2005 9:23 PM