JVC DLA-M5000SCU - Manual (Page 51)

51
Setting Up Channels (SWNo. setup)
Operating the Main Menu (Cont.)
■ Remote control unit
Note
• The selected item is shown in magenta color. Items shown
in gray color cannot be operated or set in the current mode.
(If no line is registered, you cannot set any “SW No” item.)
MEN
U/E
N
T E R
QUICK
ALIGN.
AV HIDE
OPERATE
PRESET
AV
SHIFT ZOOM FOCUS
LENS
U T +
D W –
RGB/COMPUTER
LENS
LOCK
UNLOCK
PAGE BACK
PAGE BACK button
MENU/ENTER button
1
2
3
4
5
6
7
8
9
( A U T O )
C H A N N E L
N T S C ( 4 8 0 i )
P A L / S E C A M
777777777
777777777
777777777
777777777
777777777
777777777
777777777
777777777 10
77777
77777
77777
77777
77777
77777
77777
77777
Y / C
V I D E O 1
2
77
77
77
77
77
77
77
77
CH L I N E S O U R C E SWNo
■ When a switcher number “SWNo” is selected :
The “Switcher number setup menu” is displayed.
• To be able to display a menu, a “SOURCE” needs to be already set.
1 Press MENU/ENTER toward the
2
or
3
mark to select a switcher number.
• Numbers that you can select from are numbers from 1 to 20
and characters “ 77 ” that signify non-registration.
• If you press MENU/ENTER toward the 2 mark, the number
becomes smaller, and pressing the button toward the 3 mark
makes the number larger.
• If you select “ 77 ”, “SWNo” will be deselected.
• If the selected channel is the same with the one in ( ) under
the “CHANNEL” display at the top of the CHANNEL setup
selection menu, the registration or settings cannot be cleared.
2 Press the PAGE BACK button to set.
• When you press PAGE BACK, the switcher number is set, and
the display returns to the “CHANNEL setup/selection menu”.
• Be careful that if you set the same switcher number to a few
channels and operate using the switcher number, the youngest-
number channel is switched to because channels are read in
the order of channel numbers.
(SWITCHER No. setting menu)
S W I T C H E R NO.
S W I T C H E R
1
■ CHANNEL setup • selection menu
Note
• You can automatically switch the channels of the projector by specifying a
switcher number through an external controller.
As an example, if switcher number 1 (SWNo1) has been registered to channel
number 1 (CH1), specifying switcher number 1 (SWNo1) automatically
switches the projector to channel number 1 (CH1). (For this operation, a
setup is required to communicate between the projector and the external
controller.)
For information on external controllers, contact the dealer where you
purchased your projector.
M5000LU/SCU p.44-58 01.3.5, 15:09 51