JVC 0503-FO-ID-VP - Manual (Page 57)

EN
57
Master Page: Right
Still images can be dubbed from a tape to a memory
card.
1
Load a cassette. ( ੬ pg. 18)
2
Load a memory card. ( ੬ pg. 19)
3
Set the Playback Mode Switch to “VIDEO”.
4
Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
5
Set “ COPY” to “ON”. ( ੬ pg. 35, 41)
6
Press 4·9 to start playback.
7
At the point you want to dub, press 4·9 again to
engage Still Playback.
8
To dub the image, press SNAPSHOT.
● The “ ” indication appears during
dubbing.
● The selected image is stored in the memory
card.
NOTES:
● If SNAPSHOT is pressed in step 8 when a memory
card is not loaded, the message “COPYING
FAILED” is displayed.
● If an image recorded on the tape using “DV
WIDE” ( ੬ pg. 38) is dubbed to a memory card,
the WIDE mode identifying signal is not dubbed
with it.
● To use Playback Special effects with a video image
you wish to dub, perform up to step 8 using the
remote control (provided). (
੬ pg. 60)
● Images are dubbed in the following image sizes:
Scenes recorded in HD mode: 1280 x 720 pixels
Scenes recorded in SD mode: 848 x 480 pixels
Scenes recorded in DV mode: 640 x 480 pixels
Dubbing Still Images Recorded On
A Tape To A Memory Card
Power Switch
SNAPSHOT Button
Lock Button
MENU Wheel
Play/Pause Button (4·9)
Playback Mode Switch
AD
V
A
NCED FE
A
TURE
S
GR-HD1US.book Page 57 Monday, April 14, 2003 5:21 PM