JVC LVT1306-007A User Manual
Page 51
47
❏ Changing the transmittable signals for operating
a VCR
Set the mode selector to “AUDIO/TV/VCR/STB.”
1
Press and hold VCR
.
2
Press VCR.
3
Enter the manufacturer’s code using buttons
1 – 9, and 0.
See “Manufacturers’ codes for VCR” on the right.
4
Release VCR
.
Now, you can perform the following operation on the VCR.
VCR
:
Turn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–:
Change the channel numbers on the
VCR.
1 – 9, 0:
Select the channel numbers on the VCR.
3:
Start playback.
7:
Stop playback.
8:
Pause playback.
¡:
Fast-wind a tape.
1:
Rewind a tape.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing VCR
.
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Manufacturer
Codes
JVC
01, 02
Akai
02, 37
Bell+Howell
04, 17
Blaupunkt
05
CGM
04, 06, 17
Daewoo
35
Digtal
06
Fisher
04, 17
G.E.
07
Grundig
08
Hitachi
09, 10
Loewe
06, 11, 12
Magnavox
05, 06
Mitsubishi
13 – 16
Nokia
17
Nordmende
18 – 20, 32
Orion
21
Panasonic
22
Philips
06, 23
Phonola
06
Saba
18 – 20, 24, 32
Samsung
25, 26
Sanyo
04, 17
Sharp
27, 28
Siemens
08
Sony
29 – 31, 36
Telefunken
18 – 20, 32, 33
Toshiba
34
Initial setting: 01
Manufacturers’ codes for VCR
EN44-48RXF31S[B]f.p65
05.4.14, 20:03
47