JVC LVT1306-007A - Manual (Page 45)

41
Sound reproduced from
normal stereo Sound reproduced from All
Channel Stereo mode
3D HEADPHONE mode
If you connect a pair of headphones while one of the DSP
modes is in use, the 3D HEADPHONE mode is activated
without respect to the type of software played back.
“3DHEADPHONE” appears on the display and the DSP, 3D,
and HP indicators light up.
■ MONO FILM
In order to reproduce a more acoustic sound field in your listening
room while viewing monaural sound video software (analogue
and 2-channel digital signals including Dual Mono signal), you can
use this mode.
The surround effect will be added, and the sound localization of
actor’s words will be improved.
This mode cannot be used for multi-channel digital signals.
When “MONO FILM” is used, sounds come out of all the
connected (and activated) speakers.
• If the surround speakers are set to “NO” in the speaker
setting (see page 21), JVC’s original 3D-PHONIC processing
(which has been developed to create the surround effect
through the front speakers only) is used.
The 3D indicator lights up on the display.
• If incoming signals change from 2-channel digital signal to
another digital signal type, “MONO FILM” is canceled and an
appropriate Surround mode is activated.
■ All Channel Stereo mode (ALL CH ST)
This mode can reproduce a larger stereo sound field using all the
connected (and activated) speakers.
This mode cannot be used if the surround speakers are set
to “NO” in the speaker setting (see page 21).
Activating the Surround/DSP modes
Available Surround/DSP modes vary depending on the incoming
signals. For details, see page 43.
Activating one of the Surround/DSP modes automatically
recalls the memorized settings and adjustments.
• To adjust the speaker output level, see page 29.
• To adjust the effect level for the DSP mode (except All
Channel Stereo mode,) see page 31.
• To add “wraparound” sound effect to “PLII MUSIC”
(PANORAMA control,) see page 31.
• To adjust the vertical localization of the center channel
for Surround/DSP modes (except “PLII MUSIC” and “ALL
CH ST”) (center alignment,) see page 31.
NOTES
• You cannot use any Surround/DSP modes when selecting “DVD
MULTI” as the playback source.
• You cannot select All Channel Stereo mode if the surround
speakers are set to “NO” in the speaker setting (see page 21).
• You cannot select MONO FILM mode if an incoming signal is a
multi-channel (more than 2 channel) digital signal.
• The on-screen display appears on the TV screen to show the
Surround/DSP mode name for 5 seconds when you select the
Surround/DSP mode.
To cancel the function, set “SUPERIMPOSE” to
“SUPERIMPOSE: OFF” (see page 25).
CONTINUED ON THE NEXT PAGE
EN38-43RXF31S[B]f.p65 05.4.14, 20:02 41