Select and play any source other than “dvd multi, On the front panel, Press surround – JVC LVT1306-007A User Manual

Page 46: Hall1 hall2 theatre1 theatre2

From the remote control:

When operating the receiver using
the remote control, set the mode
selector to “AUDIO/TV/VCR/STB.”

Select and play any source other than “DVD
MULTI.”

• Make sure you have selected the input mode (analogue or

digital) correctly.

Press SURROUND repeatedly to select the
Surround/DSP mode you want.

Ex.: When “DOLBY D” is selected for Dolby Digital multi-

channel software:

To cancel Surround/DSP modes

Press SURROUND repeatedly so that “SURR OFF” appears on
the display.

On the front panel:

Before you start, remember...

There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step

2 again.

Select and play any source other than “DVD
MULTI.”

• Make sure you have selected the input mode (analogue or

digital) correctly.

Press SURROUND.

MULTI JOG now works for selecting Surround/DSP modes.

Turn MULTI JOG to select the Surround/DSP
mode you want.

Ex.: When “DOLBY D” is selected for Dolby Digital multi-

channel software:

To cancel Surround/DSP modes

Turn MULTI JOG so that “SURR OFF” appears on the display.

NOTE

The initial setting is “AUTO SURR.”

* Available Surround modes vary depending on the incoming

signals. For details, see “Available Surround and DSP modes
according to the incoming signal” on page 43.

EQ
LPCM

S . WFR

NEO : 6
DSP 3D

LFE

DOLBY D

DTS AAC
96 / 24

AUTO SR

C.TONE VIRTUAL SB AUDIO P. BASS

TA NEWS INFO RDS TUNED ST

SLEEP

AUTO MUTING

AUTO MODE

ATT
HP
MHz

kHz

HALL1

HALL2

THEATRE1

THEATRE2

(Back to the beginning)

LIVE CLUB

AUTO SURR

DANCE CLUB

PAVILION

ALL CH ST

MONO FILM

Surround modes*

SURR OFF

1, 3