Juniper Networks Juniper M-series M10i - Manual (Page 56)

Table 12: MultiServices PICs Software Features Supported by the M10i Router (continued)
8.1 Stateful firewall with packet inspection: detects SYN attacks, ICMP and UDP floods, and
ping of death attacks
8.1 Network Address Translation (NAT) for IP addresses
8.1 Port Address Translation (PAT) for port numbers
8.1 IP Security (IPSec) encryption
8.1 Active flow monitoring exports cflowd version 5 and version 8 records
8.3 Active flow monitoring exports flow monitoring version 9 records, based on RFC 3954
– Passive flow monitoring
– Passive flow collection
8.2 Flow-tap
– Dynamic flow capture
8.2 Real-time performance monitoring
8.1 Link services
8.1 Tunnel services:
■ IP-IP unicast tunneling
■ GRE unicast tunneling—Supports GRE fragmentation
■ Protocol Independent Multicast (PIM) sparse mode unicast tunneling
8.1 Virtual tunnel interface for Layer 3 VPNs
8.1 Layer 2 Tunneling Protocol (L2TP)
8.1 Voice services:
■ Compressed Real-Time Transport Protocol (CRTP)
8.1 Encapsulations:
■ Multilink Frame Relay (MLFR)
■ Multilink Point-to-Point Protocol (MLPP)
56 ■ MultiServices 100 PIC
M10i Internet Router PIC Guide