Juniper Networks Juniper M-series M10i - Manual (Page 5)

Adaptive Services II PIC
■ JUNOS 6.4 and later Software release
■ Supports tunnel services. This feature is included with the PIC and does not require an
individual license.
■ Individual licenses must be purchased for additional services.
■ Power requirement: 0.4 A @ 48 V (19 W)
Description
■ Support for up to 2000 service sets
■ Active monitoring on up to 1 million flows
■ Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces
Hardware features
Depending on your JUNOS release and individual licenses, software features for this PIC can
include the features listed in Table 2 on page 5. For more information about the software
features available for services PICs, see the JUNOS Services Interfaces Configuration Guide. Software features
Status LED, one tricolor:
■ Off—PIC is offline and it is safe to remove it from the chassis.
■ Green—PIC is operating normally.
■ Amber—PIC is initializing.
■ Red—PIC has an error or failure and no further harm can be done by removing it from
the chassis.
Application LED, one bicolor:
■ Off—Service is not running.
■ Green—Service is running under acceptable load.
■ Amber—Service is overloaded.
LEDs
Table 2: Adaptive Services PICs Software Features
Adaptive Services II PIC Software Feature
7.1 GRE Key
7.0 GRE dont-fragment
6.4 Stateful firewall with packet inspection: detects SYN attacks,
ICMP and UDP floods, and ping of death attacks
Adaptive Services II PIC ■ 5
Adaptive Services II PIC