Intel D15343-003 - Manual (Page 68)

Intel
®
82854 Graphics Memory Controller Hub (GMCH)
68 D15343-003
4.8.22 SMICMD – SMI Error Command Register (Device #0)
This register enables various errors to generate an SMI Hub Interface Special cycle. When an Error
Flag is set in the ERRSTS register, it can generate a SERR, SMI, or SCI Hub Interface Special
cycle when enabled in the ERRCMD, SMICMD, or SCICMD registers respectively.
Note: An error can generate one and only one Hub Interface Error Special cycle. It is software's
responsibility to make sure that when an SMI Error Message is enabled for an error condition,
SERR, and SCI Error Messages are disabled for that same error condition.
5 SERR on Receiving Unimplemented Special Cycle Hub Interface Completion Packet :
1: The GMCH generates an SERR Hub Interface Special cycle when a GMCH initiated Hub
interface request is terminated with a Unimplemented Special cycle completion packet.
0: Reporting of this condition is disabled.
4:2 Reserved
1 SERR on Multiple-bit ECC Error :
0: This system does not support ECC, this field must be set to 0.
0 SERR on Single-bit ECC Error :
0: This system does not support ECC, this field must be set to 0.
Address Offset:
Default Value:
Access:
Size: 66h
00h
Read/Write
8 bits
Bit Description
7:4 Reserved
3 SMI on GMCH Thermal Sensor Trip :
1: An SMI Hub Interface Special cycle is generated by GMCH when the Thermal Sensor Trip
requires an SMI. A Thermal Sensor Trip Point cannot generate more than one special cycle.
2 Reserved
1 SMI on Multiple-bit ECC Error :
0: This system does not support ECC, this field must be set to 0.
0 SMI on Single-bit ECC Error :
0: This system does not support ECC, this field must be set to 0.