Invacare BUZZ HMV - Manual (Page 47)

Part No. 1118395 47
®
INSTALLING/REMOVING/USING THE WALKER
HOLDER
INSTALLATION WARNINGS
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching hardware is tightened securely.
The installation of the walker holder onto the back of the wheelchair seat
increases the length of the wheelchair up to nine (9) inches. When turning the
wheelchair it is important to take note of this increased length - otherwise,
injury and/or damage to surrounding property may result.
INSTALLING/REMOVING THE WALKER HOLDER (FIGURE 4)
NOTE: Reverse this procedure to remove the
walker holder.
1. If necessary, loosen but do not remove
the mounting knob.
2. Install the walker holder into the
accessory tube.
3. Thread the mounting knob into the
welded nut on the accessory tube.
Securely tighten.
USING THE WALKER HOLDER (FIGURE 5)
1. Fold walker. Refer to walker
instructions.
NOTE: Walker MUST be folded before using
walker holder.
2. Hang folded walker on walker holder
hooks.
3. Secure walker with hook and loop
straps.
FIGURE 5 - USING THE WALKER
HOLDER
Hook
Hook and
Loop Straps
Accessory
Tube
Mounting Knob
Seat
FIGURE 4 - INSTALLING/
REMOVING THE WALKER
HOLDER
Walker Holder
OPTIONS SECTION 10
OPTIONS