Invacare BUZZ HMV - Manual (Page 28)

28 Part No. 1118395
®
SECTION 4 SEAT ASSEMBLY
SEAT
ASSEMBLY
REMOVING/INSTALLING THE SEAT POST (FIGURE 2)
WARNING
Ensure that the seat height adjustment pin is properly engaged and locked.
Otherwise, injury and/or damage may result.
NOTE: Take note of position and orientation of the seat post and seat post pin before removing.
NOTE: The seat post has three (3) height settings. If a change in seat height is desired refer to
ADJUSTING SEAT HEIGHT in this section of the manual.
REMOVING
1. If necessary, remove the seat. Refer to REMOVING/INSTALLING THE SEAT in this
section of the manual.
2. Remove the mounting screw, two washers and locknut securing the seat post to the
frame post.
3. Lift seat post UP and remove from frame post.
INSTALLING
1. Insert the seat post into the frame post and align the frame post mounting hole with
the desired seat post mounting hole.
2. Insert mounting screw through both frame post and seat post. Install the two
washers and locknut onto mounting screw and securely tighten.
3. If necessary, install the seat. Refer to REMOVING/INSTALLING THE SEAT in this
section of the manual.
ADJUSTING SEAT HEIGHT (FIGURE 2)
1. Remove the seat. Refer to
REMOVING/INSTALLING THE
SEAT in this section of the manual.
2. Remove the mounting screw, two
washers and locknut securing the
seat post to the frame post.
3. Align the frame post mounting hole
with one (1) of three (3) seat post
mounting holes to achieve desired
seat height.
4. Insert mounting screw through both
frame tube and seat post. Install the
two washers and locknut onto
mounting screw and securely
tighten.
5. Install the seat. Refer to
REMOVING/INSTALLING THE
SEAT in this section of the manual.
FIGURE 2 - REMOVING/INSTALLING
THE SEAT POST/ADJUSTING SEAT
HEIGHT
Mounting
Screw
Locknut
Seat Post
Mounting Holes
Frame Post
Mounting Hole
Washer Washer
Seat Post