Invacare BUZZ HMV - Manual (Page 36)

36 Part No. 1118395
®
REMOVING/INSTALLING THE FRONT WHEEL
(FIGURE 3)
WARNING
Before performing any maintenance, adjustment or service, turn power
OFF and remove key from ignition.
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
REMOVING
1. Turn power OFF and remove the key
from the ignition.
2. Place the front of the powered scooter
up on blocks so that the front wheel is
OFF the ground.
3. Remove the mounting screw, locknut
and two (2) spacers that secure the
front wheel to the fork.
4. Remove front wheel from fork.
INSTALLING
WARNING
Front wheel MUST be mounted in
the bottom fork mounting hole -
otherwise, injury may result.
1. Align wheel with the fork mounting holes as shown in FIGURE 3.
2. Using the mounting screw, locknut and two (2) spacers that secure the front wheel
to the fork
3. Securely tighten front wheel mounting hardware.
SECTION 7 SHROUD/WHEELS
SHROUD/WHEELS
REMOVING/INSTALLING THE CASTER ASSEMBLIES
(FIGURE 4)
REMOVING
1. Apply a wrench to the hex nut on the caster
assembly.
2. Turn the hex nut COUNTER-CLOCKWISE to
loosen and remove the caster wheel.
3. If necessary, repeat STEPS 1-2 to remove the
other caster.
INSTALLING
1. Insert the new caster wheel into the caster
housing and turn the hex nut CLOCKWISE to
securely tighten the caster wheel in place.
Caster Housing
Wheel
Hex Nut
FIGURE 4 - REMOVING/
INSTALLING THE CASTER
ASSEMBLY
FIGURE 3 - REMOVING/
INSTALLING THE FRONT WHEEL
Fork
Mounting
Screw
Locknut
Wheel
Spacer
Fork
Mounting
Hole
Spacer