Invacare BUZZ HMV - Manual (Page 34)

34 Part No. 1118395
®
SECTION 7 SHROUD/WHEELS
Section 7 - Shroud/Wheels - includes the following:
Removing/Installing the Rear Shroud
Replacing Foam Filled Tires Onto Wheel Rims
Removing/Installing the Drive Wheels
Removing/Installing the Front Wheel
Removing/Installing the Caster Assemblies
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching hardware is tightened securely - otherwise injury or damage
may result.
Before performing any maintenance, adjustment or service, turn power
OFF and remove key from ignition.
REMOVING/INSTALLING THE REAR SHROUD
(FIGURE 1)
REMOVING
1. Remove the seat. Refer to
REMOVING/INSTALLING THE SEAT
in SECTION 4 of this manual.
2. Lift the rear shroud off of the frame
post.
INSTALLING
1. Align three (3) tabs on the rear shroud
with the three (3) slots (not shown in
figure) in the front shroud.
2. Place rear shroud on the frame and
press down slightly.
3. Install the seat. Refer to REMOVING/
INSTALLING THE SEAT in SECTION
4 of this manual.
SHROUD/WHEELS
REPLACING FOAM FILLED TIRES ONTO WHEEL RIMS
WARNING
This procedure MUST be performed by a qualified technician.
NOTE: During initial use of scooter, user may experience a flat spot on wheels. Flat spot will vanish
with continuous use of scooter.
FIGURE 1 - REMOVING/
INSTALLING THE REAR SHROUD
Rear
Shroud
Seat Post
Frame
Front Shroud
Tab