IBM N2800e - Manual (Page 55)

Appendix B. Hardware maintenance procedures
Removing the logic unit to install parts
Read Safety notices, and “Handling static-sensitive devices”
on page vi before continuing.
1. Turn off the power supply switch
A .
2. Disconnect all cables from the thin client.
3. Hold the thin client cover assembly, lift latch
B , and
pull the logic unit
C out.
4. Carefully lay the logic unit down with the internal
components facing up. You are now ready to perform
the installation procedures provided in this chapter.
5. Complete the procedure, “Reassembling the thin client”
when you are finished installing components in the logic
unit.
Reassembling the thin client
Read Safety notices, and “Handling static-sensitive devices”
on page vi before continuing.
1. To reassemble the thin client, carefully slide the logic
unit
C into the cover assembly while depressing the
slide stop
D .
2. Slide the logic unit completely into the cover assembly,
until the latch
B is engaged.
3. Perform steps 1 through 5 of the procedure, “Connecting
your hardware” on page 8.
© Copyright IBM Corp. 2000 45