IBM N2800e - Manual (Page 17)

Setting up the hardware
Unpacking your hardware
Unpack your hardware. Contact your reseller, or IBM, if
you do not have these standard parts:
1 Thin client logic unit
2 Base
3 Mouse
4 Keyboard
5 Power cable
Selecting the voltage for your location:
Attention: You may damage the thin client if you do
not select the correct voltage.
1. Locate the voltage switch
A on the bottom of the
thin client.
2. Use a pen, or similar object, to slide the switch
A to
the correct setting for your location (see ″Voltage
selection ″ in Table 11 on page 42).
Installing options:
v If you have additional memory, or optional feature
cards, see “Appendix B. Hardware maintenance
procedures” on page 45 before continuing with the
following setup procedures.
v If you have a security cable and would like to restrict
access to the thin client logic unit, thread your cable
through hole
B .
v For vertical placement of the thin client, see “Installing
the support base” on page 8.
v For horizontal placement of the hardware, continue
with “Connecting your hardware” on page 8.
© Copyright IBM Corp. 2000 7