IBM 6648 - Manual (Page 92)

POST Error Code FRU/Action
1207
1. Communications Cable
2. Dual Async Adapter/A
13XX
1. Game Adapter
1402 Printer not ready Information only
1403 No paper error, or interrupt failure Information only
1404 System board timeout failure
1. Run Enhanced Diagnostics
1405 Parallel adapter error
1. Run Enhanced Diagnostics
1406 Presence test error
1. Run Enhanced Diagnostics
14XX Not listed above. Check printer before
replacing system board
1. Printer
2. System Board
15XX
1. SDLC Adapter
1692 Boot sequence error
1. Run FDISK to ensure at least one active
partition is set active
16XX
1. 36/38 Workstation Adapter
1762 Hard disk drive configuration error
1. Run Configuration (See “Setup Utility
program” on page 41)
1780 (Disk Drive 0)1781 (Disk Drive 1)1782 (Disk
Drive 2)1783 (Disk Drive 3)
1. See “Power supply” on page 30
2. Hard Disk Drive
3. System Board
4. Riser card
5. Hard Disk Cable
6. Power Supply
180X, 188X PCI configuration or resource error
1. Run Setup and verify PCI/ISA configuration
settings.
2. If necessary, set ISA adapters to Not available to
allow PCI adapters to properly configure.
3. Remove any suspect ISA adapters.
4. Rerun diagnostics.
5. PCI Adapter
1962 Boot sequence error
1. Possible hard disk drive problem; see “Hard
disk drive boot error” on page 42
209X
1. Diskette Drive
2. Diskette Cable
78
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649