IBM 6648 - Manual (Page 21)

Diagnostic Error Code FRU/Action
005-199-XXX Video test failed, cause unknown
1. Go to the ″Undetermined problems″ section
2. Flash the system and re-test
3. Replace component under function test
005-2XX-XXX
005-3XX-XXX
Video subsystem error
1. Video card, if installed
2. System board
006-000-XXX Diskette interface Test Passed
1. No action
006-0XX-XXX Diskette interface error
1. Diskette drive Cable
2. Diskette drive
3. System board
006-195-XXX Diskette interface Test aborted by
user
1. Information
2. Re-start the test, if necessary
006-196-XXX Diskette interface test halt, error
threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
006-197-XXX Diskette interface test warning
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
006-198-XXX Diskette interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the ″Undetermined problems″ section
006-199-XXX Diskette interface test failed, cause
unknown
1. Go to the ″Undetermined problems″ section
2. Flash the system and re-test
3. Replace component under function test
006-25X-XXX Diskette interface Error
1. Diskette drive cable
2. Diskette drive
3. System board
011-000-XXX Serial port Interface Test Passed
1. No action
011-001-XXX Serial port Presence
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
011-002-XXX
011-003-XXX
Serial port Timeout/Parity error
1. System board
Chapter 1. IBM PC Enhanced Diagnostics error codes 7