IBM HL-5250DN User Manual
Page 25
2. Printing Methods
17
e
Put paper in the MP tray. Make sure that the paper stays under the maximum paper mark (b) on both
sides of the tray.
Note
• Envelope joints that are sealed by the manufacturer should be secure.
• The side to be printed on must be face up.
• All sides of the envelope should be properly folded without wrinkles or creases.
f
While pressing the paper-guide release lever, slide the paper guide to fit the paper size.
g
Send the print data to the printer.
Note
• Remove each sheet or envelope at once after printing. Stacking the sheets or envelopes may cause the
paper to jam or curl.
• If envelopes get smudged during printing set the Media Type to Thick Paper or Thicker Paper to
increase the fixing temperature. To adjust the print density setting, see Printing on thick paper, labels and
envelopes on page 15.
• If the envelopes is creased after they are printed, see Improving the print quality on page 91.