IBM 5000 - Manual (Page 89)

Completing the Installation
Completing the Rack Model Installation
1. Replace the top cover:
a. Align the top cover with the top of the server, about 25 mm (1 inch) from
the front of the server.
b. Hold the cover against the server and slide the cover toward the front of
the server until the cover clicks into place.
Note: Be sure the front edge of the cover is flat against the server.
c. Turn the captive thumbscrew 1 until the cover is secured.
2. Replace the bezel, if it was removed.
a. Place the bezel tabs 2 in the slots at the left front of the server.
b. Press the right end of the bezel toward the server front until the bezel clicks
into place.
Chapter 4. Installing Options 79