IBM 5000 - Manual (Page 109)

Installing the Rack Model in a Rack Enclosure
4. Attach the slide rail to the right side of the rack enclosure.
a. Extend the outer slide rail until the slide bracket is flush against the outside
of the right front mounting rail. Align the slide bracket with the cage nuts
on the mounting rail.
b. From the front of the rack enclosure, insert two long screws through the
slide bracket and mounting rail. Press the slide rail so that it is flush with
the outer edge of the mounting rail and tighten the screws.
c. Attach the slide bracket to the right rear of the rack enclosure.
1) Align the holes on the bracket with the cage nuts on the rear mounting
rail.
2) From the rear of the rack enclosure, insert a long screw through holes
in the slide bracket and mounting rail; then, tighten the screws.
5. Attach the cable-management arm to the right rear of the rack enclosure.
a. Align the holes on the cable-management arm mounting panel with the
cage nuts on the rear mounting rail.
100 Netfinity 5000 Server Hardware Information and Procedures