ICP DAS USA DB25 - Manual (Page 43)

DeviceNet to Motor Drives
37
C
OMMAND
B
LOCK
Using I/O data to update and/or monitor motor drive parameters requires very little programming in your
DeviceNet Host device – the configuration of the DN-3000 specifies which motor drive parameters are
mapped to which words of I/O data. However, you can only access a total of 32 motor drive parameters
this way, and those parameters are fixed when the DN-3000 is configured. If your application requires
that you access more than 32 motor drive parameters, you must either use multiple DN-3000s, or use a
Command Block.
A Command Block allows your DeviceNet Host to issue commands at run-time to read or write any valid
parameter of any motor drive connected to Port 2 of the DN-3000. The Command Block reserves the first
3 words of Output data for commands issued by the Host, and the first 3 words of Input data for the
results of those commands (along with any returned data). Commands are issued by moving a Motor
Drive Address, Parameter Number, any required Parameter Data (for write commands only), and a
Command code into the Command Block, as follows:
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
word 1 Motor Drive Address (0-255) 0 0 0 0 Command
word 2 Parameter Number
word 3 Parameter Data (write command only)
The DN-3000 looks for changes in the Command Block data to determine when there is a new request to
be processed, “throwing out” any invalid commands received. Valid Commands are 1 (read) and 2
(write). To ensure that partial commands are not processed (in systems where it is possible that Output
data could be sent by the host before all 4 words of data have been moved into the command block), you
should set the Command to 0 (indicating no command), then place the data in words 2-3, and only set the
Command to 1 or 2 after all of the other data is in place. After a command has been processed by the DN-
3000, it will “echo” the command in the Command Result Block in the Input data, and set the Result Code
and any Returned Parameter Data, as follows:
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
word 1 Motor Drive Address (0-255) 1 Result Code Command
word 2 Parameter Number
word 3 Returned Parameter Data (read command only)
If a read command (1) was issued, the Returned Parameter Data will contain the parameter data read
from the specified Motor Drive. If a write command (2) was issued, the Returned Parameter Data will be
the same as for the issued command. The Result Code indicates the result of processing the issued
command. Valid Result Codes are as follows:
Result Code Meaning
0 Command was completed successfully.
1 DN-3000 could not communicate with indicated motor drive.
2-6 Drive specific error code (see “Application Notes” for motor drive).
7 Command was invalid.