IBM 4190 - Manual (Page 61)

- System-BMC Serial Port Sharing
Select this choice to specify whether the serial port that the BMC uses is
shared with the rest of the system or is dedicated to the BMC. This choice,
together with the BMC Serial Port Access Mode setting, affects
serial-related behavior and remote-management capabilities on this server.
For more information, see the help for this choice.
- BMC Serial Port Access Mode
Select this choice to specify the access mode for the serial port. This
choice, together with the System-BMC Serial Port Sharing setting, affects
serial-related behavior and remote-management capabilities on this server.
For more information, see the help for this choice.
- Reboot System on NMI
Select this choice to enable or disable the ability of the server to restart
after an NMI interrupt is issued. If the value is Enabled, this setting
supersedes the automatic server restart (ASR) setting.
- User Account Settings
Select this choice to view the settings for each BMC user ID, change the
password for a BMC user ID, and set the maximum BMC privilege level.
- BMC Network Configuration
Select this choice to view the mini-BMC MAC address, IP address, subnet
mask, gateway address, host name, and DHCP control setting.
- BMC System Event Log
Select this choice to view the BMC system-event log, which contains all
system-error messages that have been generated. Use the arrow keys to
move among pages in the log. Run the diagnostic programs to get more
information about error codes that occur. See the Problem Determination
and Service Guide on the IBM System x Documentation CD for
instructions. To clear the BMC system-event log, select Clear BMC SELs
and confirm the selection.
The BMC system-event log is limited in size. When the log is full, new
entries will not overwrite existing entries; therefore, you must periodically
clear the BMC system-event log. When you are troubleshooting an error, be
sure to clear the BMC system-event log so that you can find current errors
more easily.
– High Precision Event Timer
Select this choice to enable or disable the high precision event timer (HPET)
function.
v Event/Error Logs
Select this choice to view or clear error logs.
– System Event/Error Log
Select this choice to view the complete log of POST error messages. Use the
arrow keys to move among pages in the log.
Run the diagnostic programs to get more information about error codes that
occur. See the Problem Determination and Service Guide on the IBM System
x Documentation CD for instructions.
To clear the system event/error log, select Clear System Event/Error Log
and confirm the selection.
The system event/error log is limited in size. When the log is full, new entries
will not overwrite existing entries; therefore, you must periodically clear the
system event/error log. When you are troubleshooting an error, be sure to
clear the system event/error log so that you can find current errors more
easily.
Chapter 3. Configuring the server 47