Middleby Cooking Systems Group PS360/PS360WB - Manual (Page 33)

2-19
SECTION 2
INSTALLATION
INSTALLING THE CONVEYOR FRAME AND BELT
1. Insert the conveyor frame into the oven as follows:
For TRI TANDEM ovens, slide
one center section and one end
section of the frame into EACH
END of the oven. The four sections
should butt against each other.
For QUAD TANDEM ovens, slide
two intermediate sections and one
end section of the frame into EACH
END of the oven. Butt the two
inner intermediate
sections against the
transition (center) frame
section. The other
frame sections should
butt against each other.
FOR ALL TYPES OF OVENS, ENSURE THAT THE DRIVE
SECTION/END OF THE CONVEYOR FRAME IS PLACED ON
THE SAME END OF THE OVEN AS THE CONVEYOR DRIVE
MOTOR.
Figure 2-25a
Installing the Conveyor Frame-
Tandem and Double Tandem Ovens
Figure 2-25b
Installing the Conveyor Frame-
Tri Tandem Ovens
Figure 2-25c
Installing the Conveyor Frame-
Quad Tandem Ovens
For a TANDEM or DOUBLE
TANDEM oven, slide the conveyor
frame assembly into either end of
the oven.