Monessen Hearth HVFL18 User Manual
Page 26
26
59D1015
ROCK WOOL
AND
LOG PLACEMENT
Figure 26 - Installing Back Log
Before you begin
— This unit is supplied with four or five ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands
gently with soap and water to remove any traces of fibers.
The positioning of the logs are critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the logs and EB-RW (rock wool) supplied
with the unit.
Failure to position the parts in accordance with diagrams below or to use only
parts specifically approved for this heater may result in property damage or
personal injury.
W
ARNING
INSTALLING KENTUCKY STACK LOGS ON GRATE
1. Install back log (#1) on two pins located near the back of
base. Check log position and stability. See Figure 26.
Back Log #1
Pins
PLACING ROCK WOOL
Starting on the second row of burner ports,
place EB-RW (Rock Wool) in dime-size pieces
on the second row of ports and going toward
back of front burner.
.
Figure 25 - Placing Rock Wool
Dime-Size
Rock Wool
• Use only EB-RW provided with log set.
• Do not add additional rock wool.
• Place EB-RW (rock wool) on front burner
ports only. DO NOT PLACE EB-RW ON
BACK BURNER!
W
ARNING
NOTE: Do not put EB-RW (Rock Wool) on first row of
burner ports.
First Row of Ports
(Leave Open)