Motorola MVME2400 User Manual
Page 6
!
WARNING
This equipment generates, uses, and can radiate electro-magnetic energy. It may
cause or be susceptible to electro-magnetic interference (EMI) if not installed
and used in a cabinet with adequate EMI protection.
If any modifications are made to the product, the modifier assumes
responsibility for radio frequency interference issues. Changes or modifications
not expressly approved by Motorola Computer Group could void the user’s
authority to operate the equipment.
European Notice: Board products with the CE marking comply with the EMC
Directive (89/336/EEC). Compliance with this directive implies conformity to the
following European Norms:
EN55022 “Limits and Methods of Measurement of Radio Interference Characteristics of Infor-
mation Technology Equipment”. Tested to Equipment Class B.
EN 50082-1:1997 “Electromagnetic Compatibility -- Generic Immunity Standard, Part 1. Res-
idential, Commercial and Light Industry.”
EN 61000-4.2 -- Electrostatic Discharge Immunity Test
EN 61000-4.3 -- Radiated, Radio-Frequency Electromagnetic Field, Immunity Test
EN 61000-4.4 -- Electrical Fast Transient/Burst Immunity Test
EN 61000-4.5 -- Surge Immunity Test
EN 61000-4.6 -- Conducted Disturbances Induced by Radio-Frequency Fields -- Immunity
Test
EN 61000-4.11 -- Voltage Dips, Short Interruptions and Voltage Variations Immunity Test
ENV 50204 -- Radiated Electromagnetic Field from Digital Radio Telephones -- Immunity
Test
In accordance with European Community directives, a “Declaration of Conformity” has been
made and is on file at Motorola, Inc. - Computer Group, 27 Market Street, Maidenhead, United
Kingdom, Sl6 8AE.
This board product was tested in a representative system to show compliance with the above
mentioned requirements. A proper installation in a CE-marked system will maintain the
required EMC/safety performance.
For minimum RF emissions, it is essential that you implement the following conditions:
1. Install shielded cables on all external I/O ports.
2. Connect conductive chassis rails to earth ground to provide a path for connecting shields to
earth ground.
3. Tighten all front panel screws.
The product also fulfills EN60950 (product safety) which is essentially the requirement for the
Low Voltage Directive (73/23/EEC).