beautypg.com

Secondary pmcspan, Secondary pmcspan -18 – Motorola MVME2400 User Manual

Page 34

background image

1-18

Computer Group Literature Center Web Site

Preparing and Installing the MVME2400-Series Module

1

4. Attach the four standoffs to the MVME240x module. For each

standoff:

– Insert the threaded end into the standoff hole at each corner of

the VME processor module.

– Thread the locking nuts onto the standoff tips.

– Tighten the nuts with a box-end wrench or a pair of needle nose

pliers.

5. Place the PMCspan on top of the MVME240x module. Align the

mounting holes in each corner to the standoffs, and align PMCspan
connector P4 with MVME240x connector J6.

6. Gently press the PMCspan and MVME240x together, making sure

that P4 is fully seated into J6.

7. Insert the four short Phillips screws through the holes at the corners

of the PMCspan and into the standoffs on the MVME240x module.
Tighten the screws.

Note

The screws have two different head diameters. Use the
screws with the smaller heads on the standoffs next to
VMEbus connectors P1 and P2.

Secondary PMCspan

The PMCspan-010 PCI expansion module mounts on top of a PMCspan-
002 PCI expansion module. To install a PMCspan-010 on your
MVME240x, refer to Figure 1-5 and perform the following steps. This
procedure assumes that you have read the user’s manual that was furnished
with the PMCspan, and that you have installed the selected PMCs on the
PMCspan according to the instructions given in the PMCspan and PMC
manuals.

1. Attach an ESD strap to your wrist. Attach the other end of the ESD

strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground while you are performing the installation
procedure.