Motorola MVME2400 - Manual (Page 106)

6-4 Computer Group Literature Center Web Site
Modifying the Environment
6
Remote Start Method Switch [G/M/B/N] = B?
The Remote Start Method Switch is used when the MVME2400 is
cross-loaded from another VME-based CPU, to start execution of the
cross-loaded program.
Probe System for Supported I/O Controllers [Y/N] = Y?
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
G Use the Global Control and Status Register to pass
and start execution of the cross-loaded program. This
selection is not applicable to the MVME2400 boards.
M Use the Multiprocessor Control Register (MPCR) in
shared RAM to pass and start execution of the cross-
loaded program.
B Use both the GCSR and the MPCR methods to pass
and start execution of the cross-loaded program.
(Default)
N Do not use any Remote Start Method.
Y Accesses will be made to the appropriate system
buses (e.g., VMEbus, local MPU bus) to determine
the presence of supported controllers. (Default)
N Accesses will not be made to the VMEbus to
determine the presence of supported controllers.
Y NVRAM (PReP partition) header space will be
initialized automatically during board initialization,
but only if the PReP partition fails a sanity check.
(Default)
N NVRAM header space will not be initialized
automatically during board initialization.