Debug port, Debug port -5, 2debug port – Motorola MVME2400 User Manual
Page 45
MVME240x
http://www.mcg.mot.com/literature
2-5
2
DEBUG Port
The RJ45 port labeled
DEBUG
on the front panel of the MVME240x
supplies the MVME240x serial communications interface, implemented
via a UART PC16550 controller chip from National Semiconductor. It is
asynchronous only. This serial port is configured for EIA-232-D DTE, as
shown in Figure 2-1.
The
DEBUG
port may be used for connecting a terminal to the MVME240x
to serve as the firmware console for the factory installed debugger,
PPCBug. The port is configured as follows:
❏
8 bits per character
❏
1 stop bit per character
❏
Parity disabled (no parity)
❏
Baud rate = 9600 baud (default baud rate at power-up)
After power-up, the baud rate of the
DEBUG
port can be reconfigured by
using the debugger’s Port Format (PF) command. Refer to Chapters 5 and
6 for information about PPCBug.