MITSUBISHI ELECTRIC PE-15MYC - Manual (Page 6)

FEATURES
- 5-
DESCRIPTIONS
High sensible cooling capacity.
The sensible cooling capacity has been significantly
improved through balanced optimised heat
exchanger design.
Comfort heating. (PEH only)
Highly efficient operation.
The EER(Energy Efficiency Ratio) on these models
is greatly improved by revised design specifications
and by being manufactured stringently to Mitsubishi
Electric high quality standards.
Flexibility of Supply Air Delivery
PE, PEH-15,20 feature belt driven Supply Air fans
enabling accurate matching of actual airflow rates
to the specified quantities. Accurate commissioning
is assisted by the capability to change pulleys and
belts if necessary to achieve the desired air balance.
Labour saving installation.
The unit operation can commence immediately after
connecting to the power supply, refrigerant piping,
drain piping, ducting and control system.
Low ambient cooling. (Special order)
In applications with relatively high internal loads,
there may be a requirement for all series to
operate on cooling at low ambient conditions.
Special order parts is available to maintain the
refrigeration circuit in balance at outdoor temperatures
as low as -5 .
Please consult your local Mitsubishi Electric Sales
office for application advice on these parts.
Wide electrical control capability.
The PEH series are designed to provide effective
heating even when the outside temperature is down
to -10 .
All series is flexible mechanical control
configuration.
In addition Global Remote Controller is prepared as
special order.
The Global Remote Controller gives the programmable
weekly timer, compressor anti-short cycle timer(3min.),
cool/heat/fan/auto changeover etc.(Heat and auto
changeover are only PEH.)
The factory standard is for provision of 24 volt terminal
block to enable a field wired control of contractors
choice to be connected.
Please consult your local Mitsubishi Electric Sales
office for application advice on these control.
Mitsubishi Electric air conditioners series PE(H)/PU(H)
are available in a wide range of sizes and models to
enables the designer to select the best model for
each application.
All series units are completely assembled, wired and
strictly tested at the factory. With the development of all series demands
for such features as light weight, compactness,
increased capacity, appropriate static pressure, air
flow control, and having flexibility of inter facing
energy saving electronic controls, Mitsubishi
Electric have met market expectations.
Grobal Remote Controller