Memorex MLT1522 - Manual (Page 22)

TV OPERATION
21
Adjust the volume level by pressing the VOLUME
UP/Navigation Right 1 or VOLUME DOWN/Navigation Left
2
button. The volume level will be indicated on the screen
by a green bar.
3
For proper operation, before selecting channels, they
must be set into the TV’s program memory, see page 19-20.
Press and release the CHANNEL/Navigation UP 1 or
DOWN 2 button. The TV automatically stops at the next
channel set into memory. This will not operate if channels
are not set into memory.
Direct Program Selection buttons (0-9) 3.
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen.
• For Channels 01 through 99, press the two digits in order.
• For Channels 100 through 125, press the 1-- button 4,
then the remaining two digits.
4
Set the AirTV/CATV (CABLE) option and set the channels
into memory as described on pages 19 and 20.
2
Press the POWER button 1 to turn on the TV; the
POWER indicator will light orange. Press the TV/VIDEO
button 2 repeatedly to select the TV mode.
1
OPTIONS
AirTV: If using a
VHF/UHF
antenna.
CATV: If using Cable
TV.
NOTES:
• When AIR/CATV is set to AIR, only channels up to 69
can be selected. When set to CATV, channels up to
125 can be selected.
• If an invalid channel is selected, the display will revert
to the original channel.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
TV SETUP option must be set to CATV when using cable, see page 19.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.