Mercedes-Benz 2004 E 320 - Manual (Page 262)

262
Controls in detail
Useful features
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the inte-
grated signal transmitter button (1,
2 or 3) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter 6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp 4 will flash slowly and
then rapidly after several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control
̈ Switch on ignition.
̈ Select and press the appropriate inte-
grated signal transmitter button (1,
2 or 3) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.