Mercedes-Benz 2004 E 320 - Manual (Page 146)

146
Controls in detail
Control system
Lighting submenu
Access the Lighting submenu via the Set-
tings menu. Use the Lighting submenu
to change the lamp and lighting settings on
your vehicle. The following functions are
available:
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
the
æ or ç button to the
Lighting submenu.
̈ Press button j or k repeatedly
until you see this message in the dis-
play:
Lamp circuit headlamp .
The selection marker is on the current
setting.
̈ Press æ or ç to select
manual or
daytime running lamp ( constant )
mode. This function is not available in
countries where daytime running
lamps are mandatory.
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps (in low ambient
light conditions)
Function Page
Set daytime running lamp mode
(USA only) 146
Set locator lighting 147
Ambient light level 147
Exterior lamps delayed shut-off 148
Interior lighting delayed shut-off 149
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting submenu to factory settings
( ୴ page 138) while driving will not re-
set the daytime running lamp mode.
In the display you will then see the mes-
sage:
Lighting