MITSUBISHI ELECTRIC WD-60C8 - Manual (Page 79)

Appendices 79
Resolving CEC Conflicts, Changing HDMI
Connections, Removing HDMI Devices
Because each manufacturer selects which CEC func-
tions to support, some devices can conflict with other
devices. If control conflicts arise, you can:
Turn off CEC in the other device’s setup menu. •
Turn off TV control of an individual CEC device (see •
fiugre 5 below).
Reset TV control of an individual CEC device (see
•
figure 6 below).
Turning Off the TV’s HDMI Control of an Individual
CEC Device (Figure 5)
Press 1. MENU on the TV remote control to enter the TV
Main menu.
Select the
2. Inputs menu using the keys.
Select the
3. Inputs > Name menu using the key.
Highlight the device to remove using the 4. key and
then the key.
With the device highlighted, select
5. Control Off to
turn off the TV’s ability to control the device.
Press
6. EXIT to clear the menus.
Figure 5. Inputs > Name menu with HDMI Control for
AVR Tuner turned off
Resetting HDMI Control or Removing an HDMI
Device (Figure 6)
Power off the device.
1.
If removing the device, disconnect the HDMI cable. 2.
Press 3. MENU on the TV remote control to enter the TV
Main menu.
Select the
4. Inputs menu using the keys.
Select the 5. Inputs > Name menu using the key.
Highlight the device to reset using the 6. key and
then the key.
With the device highlighted, select
7. Delete to reset
HDMI Control.
Press
8. EXIT to clear the menus.
If the device is still connected, the Auto Input
Sensing screen will display.
Figure 6. Inputs > Name menu with AVR DVD deleted.
Using NetCommand HDMI Control
As an example of using NetCommand for HDMI
devices, you would press
PLAY on the device itself to:
Turn on the TV if not already on •
Switch to the device (no need to display the • Input
Selection menu)
Begin play of the device
•
Test your equipment with the TV’s remote control to
find out which commands are supported. See the table
below for commands that may be available, depending
on the individual device.
CEC-enabled VCR, DVD, and DVR functions that
may be available:
Record/
Playback
Menu
Navigation
Channel Tuning Other
CH / GUIDE
ENTER
Digits 0–9,
—
CANCEL F1 (content)
*
—
CANCEL
(to cancel)
ENTER MENU
* The F1 key defaults to work like the device’s LIST key.
If you have a CEC-enabled A/V receiver, CEC-enabled
devices connected to the A/V receiver with an HDMI
cable may also be controllable. They can be selected
from the TV’s
Input Selection menu.
CEC-enabled A/V receiver functions that may be
available:
Try the • VOL, MUTE, and menu-navigation keys.
To open the A/V receiver menu, follow these steps: •
While watching TV, press 1. AUDIO.
Press 2. repeatedly until the Speakers option
displays.
While
3. Speakers is still displayed, press MENU.
736 or 835 Series TV. You can use NetCommand IR
“learning” to add commands to those supported by
CEC. You must first connect and place IR emitters for
the devices.