MITSUBISHI ELECTRIC WD-60C8 - Manual (Page 13)

2. TV Setup 13
Initial TV Setup
Use the Setup menu for basic TV setup options.
Press 1. MENU to open the Main menu.
Press
2.
to highlight the Setup icon and display the
Setup menu.
Memorizing Channels
For ANT 1 and ANT 2
To start channel memorization
With the 1. Setup menu displayed, press to high-
light the Scan icon.
Start channel memorization from the Setup menu.
Press 2. to highlight an input selection based on
your connections:
Input Condition
Ant 1 Air
Ant 2 Air When connected to an indoor or
outdoor antenna
Ant 1 Cable
Ant 2 Cable When connected to direct cable (no
cable box)
Press 3. to highlight the on-screen START button.
Press 4. ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
When memorization is complete you can:
5.
• Press MENU once to return to the top row of icons.
• Press MENU again to return to the Main menu.
• Press EXIT to watch TV.
After channels have been memorized:
• To tune to memorized channels, press
CH /
while watching TV on the ANT 1 or ANT 2 inputs.
• Use the Setup > Edit menu (page 44) for additional
channel options, such as adding or deleting chan-
nels from memory, naming channels, and saving
favorite channels in custom memory banks.
See chapter 5, “TV Menu Settings,” to:
• Set the TV clock (page 45)
• Set the TV Timer (page 46)
• Select an Energy Mode to manage power use while
the TV is off (page 47)
• Select a lamp brightness mode (page 47)
• Enable 3D video (pages 35 and 47)
Setting Up TV Inputs
When You First Connect a Device
The TV’s Easy Connect™ Auto Input Sensing feature
detects most connections automatically.
Note: For connection and setup of a personal com-
puter, see the information on page 17.
Auto Input/Auto Output Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connected device and automatically
switch to it
b. Prompt you to identify the device type
c.
736 or 835 series TV. Prompt you to perform
NetCommand set-up for the device, if available.
d. Repeat these steps for any additional newly
detected devices
See below for connections which trigger Auto Sensing.
Auto Input Sensing Available
Y/VIDEO (detected as composite video)
Y plus Pb (detected as component video)
S-VIDEO
HDMI
*
USB (USB photo port on front)
INPUT 4 AUDIO (for an audio-only device; see page 25.)
Auto Output Sensing Available
DIGITAL AUDIO OUTPUT (orange jack)
AVR AUDIO OUTPUT (red jack)
No Auto Sensing
ANT 1 and ANT 2
* If the device is powered off when connected, detec-
tion occurs when the device is next powered on.
Auto Input/Auto Output Sensing for CEC Devices
When the TV’s NetCommand for HDMI feature is active,
most CEC-enabled devices are recognized and identified
automatically by the TV. NetCommand for HDMI may
allow you to control functions of a CEC-enabled device.
See Appendix E, “NetCommand HDMI Control of CEC
Devices,” page 77.