MITSUBISHI ELECTRIC WD-60C8 - Manual (Page 26)

26 TV Operation and Features
4
Choosing a Viewing Source
Input Selection menu
Choose a viewing source from the Input Selection
menu. The current TV input appears as a full-color icon
in this menu.
Press 1. INPUT to display the Input Selection menu. If
there are only two inputs to the TV, INPUT switches
between them without displaying the menu.
Highlight an input icon using
2. .
Press 3. ENTER to switch to the input and close the
menu.
More About the Input Selection Menu
• To assign meaningful names to the icons, see the
Inputs > Name menu, page 48.
• To rearrange the icons, see the Inputs > Order
menu, page 48.
Sleep Timer
The Sleep Timer turns the TV off after the length of time
you set. To set the TV to turn on at a certain time, see
the
Setup > Timer menu on page 46.
Setting the Sleep Timer
Press 1. SLEEP on the remote control.
Press
2. SLEEP additional times to increase the time in
30-minute increments up to the maximum of 120
minutes.
Press
3. EXIT or wait five seconds without pressing any
keys for the message to disappear.
Press
4. SLEEP to view the time remaining before the
sleep timer turns off the TV.
Cancelling the Sleep Timer
Press
1. SLEEP to display the on-screen message.
Press 2. SLEEP repeatedly until OFF is displayed.
Note: After five seconds of inactivity, the message box
will disappear.
TV Tips
Turning the TV On or Off
To turn the TV on or off, point the remote control at the
front of the TV and press the
POWER button. Alterna-
tively, press the POWER button on the control panel of the
TV.
If You Turn Off the TV by Mistake
Press 1. POWER again within about 60 seconds (while
the lamp is still hot) to have the TV come back on
immediately.
If the
2. LAMP indicator starts blinking (about 60
seconds after you shut off power), wait a few
moments for the LAMP indicator to stop blinking
and press POWER to turn the TV on again.
Controlling Sound Volume
Press • VOL / to adjust the sound level.
See also “Controlling A/V Receiver Sound Volume” on •
page 15.
Changing Channels (antenna sources)
To change channels:
Enter the channel number using the number keys •
on the remote control and press ENTER. For a two-
part digital channel, such as 3-1, press 3
—
CANCEL 1
to enter a dash (separator).
Press
• CH/PAGE / to change channels one
channel at a time.
Press and hold
• CH/PAGE / to move quickly
through channels.
Press
• QV (QuickView) to switch back to the previ-
ously tuned channel.
Press
• GUIDE to display ChannelView channel listings,
highlight a channel, and press ENTER to select.
Use the Fav (Favorites) feature to set up lists of •
favorite channels and tune to them with the FAV key.
See Setup > Edit > Fav 1–Fav 6 on page 44.
NOTE: Perform channel memorization to make finding
channels easier. See Setup > Scan, page 43.