MITSUBISHI ELECTRIC WD-60C8 - Manual (Page 63)

6. NetCommand IR Control (736 and 835 Series TVs) 63
Setting Up NetCommand Control of an A/V Receiver, continued
Press 3. ENTER and the highlighted Input label will start
flashing to indicate readiness for “learning.”
While the
4. Input text is flashing, press and hold the
key on the A/V receiver’s remote control for the
input you wish to associate with the selected Input
label.
When a check appears next to the
5. Input label,
release the remote control key.
• If the text stops flashing before the check mark
appears, repeat this step.
• To erase the IR code just “learned,” press CANCEL
while the name is highlighted.
On the 6. TV’s remote control, press once. The
highlight will move automatically to the associ-
ated
Assign Input column (Assign Input1 through
Assign Input5).
Use
7.
to highlight the device type connected to
the A/V receiver input just “learned.” The Assign
Input column contains a list of possible device
types.
In the example above, a DVD player is connected to
the A/V receiver input the TV knows as
Input2.
The device type you select here will appear as an
icon in the TV’s
Input Selection menu. You can
assign each device type in the list only once.
Press
8. EXIT if finished or repeat these steps for addi-
tional video sources connected to the A/V receiver.
NetCommand IR Control: Device
Connected to an A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
Set up NetCommand control of A/V receiver audio/
1.
video switching via HDMI as described on the
opposite page.
HDMI
Cable
TV
Any Con-
nection Type
Source
Device
A/V Receiver
Press 2. EXIT to close any open menus and return to
normal TV viewing.
Press
3. INPUT to open the Input Selection menu.
Highlight the icon for the A/V receiver input you 4.
wish to control.
The A/V receiver’s remote control key for the input
must have been “learned” previously using “Setup
to Control Automatic Audio and Video Switching via
HDMI” on the opposite page.
Press
5. ENTER to switch the TV to the A/V receiver and
the A/V receiver to the device.
Open the
6. Inputs > Learn menu.
Perform NetCommand “learning” for the device by 7.
following the steps in “Initial NetCommand Setup
for Most Devices,” page 54.