Multiquip High Pressure Centrifugal Pump (Honda GX340K1PKT2/GX340U1PKT2 Gasoline Engine) QPT305SLT - Manual (Page 17)

Qp305SLT/QpT305SLT CeNTRIFUgaL pUMp • opeRaTIoN aNd paRTS MaNUaL — Rev. #1 (10/11/10) — page 17
OperatiOn
This section is intended to assist the operator with the
initial start-up of the pump. It is extremely important that
this section be read carefully before attempting to use the
pump in the field.
STaRTINg THe eNgINe (HoNda)
1. Place the engine fuel valve lever (See Figure 6) to the
“ON” position.
Figure 6. Engine Fuel Valve Lever (ON Position)
2. Move the throttle lever (See Figure 7) away from the
slow position, about 1/3 of the way toward the fast
position.
Figure 7. Throttle Lever (1/3 Start Position)
CaUTIoN
do NoT attempt to operate the pump
until the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
3. Place the choke lever (See Figure 8) in the “CLOSED”
position if starting a cold engine.
Figure 8. Engine Choke Lever (Closed)
4. Place the choke lever (See Figure 9) in the “OPEN”
position if starting a warm engine or the temperature
is warm.
Figure 9. Engine Choke Lever (Open)
5. Place the engine ON/OFF switch (See Figure 10) in
the “ON” position.
Figure 10. Engine ON/OFF Switch (ON Position)