Monessen Hearth Direct Vent Gas Insert IDV490NVC - Manual (Page 24)

24 57D0016
SURROUND INSTALLATION
INSTALLING FACING
1. Remove glass. See Page 31.
2. Line up plain or beveled surround with unit opening.
3. Attach surround to unit with six (6) screws provided. See Figures 26 and 27.
4. Install glass.
INSTALLING ON/OFF SWITCH
1. After installing surround, disconnect the
on/off switch from wires leading from
heater.
2. Insert switch into hole in upper right
side of the trim. See Figure 28.
3. Reattach wires. See Figure 28.
Figure 26 - Installing Plain Surround
Figure 28 - Installing On/Off Switch
On/Off Switch -
Tape wires to back
of surround with
foil tape.
Plain Surround Beveled Surround
Screws
Screws
Figure 27 - Installing Beveled Surround