METRObility Optical Systems 8124-01-M - Manual (Page 20)

20 CenturyStack 8100 Managed Hub
10Mbps connections. All ports are hot pluggable. It is recommended you
label each cable to identify the device or port at each end.
Connecting Devices
Connecting Workstations
Install either a 10BASE-T or a 100BASE-TX Fast Ethernet Network
Interface Card into each workstation if not already installed. Using a
UTP/STP cable, connect the Ethernet card (in the workstation) to a
CenturyStack port.
Connecting Ethernet Hubs or Devices
Connect 10Mbps devices using UTP/STP Cat 3, 4 or 5 cables with RJ-45
connectors, enabling sending/receiving to or from other 10Mbps devices.
By default, each port is set in auto sensing mode. CenturyStack can detect
a 10BASE-T device and transmit/receive information to/from it.
MDI-II MDI-II
1x 2x 3x 4x 5x 6x 9x 8x 7x 10x 11x 12x
13x 14x 15x 16x 17x 18x 21x 20x 19x 22x 23x 24x
10/100 Mbps Dual Speed Ethernet Hub
Switch Module
Installed
Shared Ports Shared Ports
Connecting Ethernet Hubs
10Mbps
CenturyStack 81XX