Mercedes-Benz 2003 CL 500 - Manual (Page 46)

46
Getting started
Driving
Switching on headlamps
Exterior lamp switch
1 Off
2 Low beam headlamps on
̈ Turn the switch to B.
More information can be found in the
“Controls in detail” section (
୴ page 108).
Turn signals and high beam
The combination switch is on the left of the
steering column.
Combination switch
1 Turn signals, right
2 Turn signals, left
̈ Press the combination switch up 1 or
down 2.
High beam
̈ Push the combination switch forward.
The high beam headlights are switched
on.
The high beam symbol A in the
tachometer lights up.
More information can be found in the
“Controls in detail” section (
୴ page 111).
Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.
i
To signal minor directional changes,
e.g. passing or changing lanes, move
combination switch to point of resis-
tance only and release. The turn signal
blinks three times.