Mercedes-Benz 2003 CL 500 - Manual (Page 136)

136
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
the æ or ç button to the
LIGHT-
ING submenu.
̈ Press button j or k repeatedly
until you see this message in the dis-
play:
LIGHT CIRCUIT HEADLIGHT MODE .
The selection marker is on the current
setting.
̈ Press æ or ç to select manual
or daytime running lamp (constant)
mode. This function is not available in
countries where daytime running
lamps are mandatory.
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps (in low ambient
light conditions)
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U , the locator lighting fea-
ture is activated and the vehicle is un-
locked by remote control:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
The locator lighting switches off when the
driver’s door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
̈ Move the selection marker with
the æ or ç button to the
LIGHT-
ING submenu.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
LIGHTING submenu to factory settings
( ୴ page 132) will not reset the daytime
running lamp mode.
In the display you will then see the mes-
sage:
LIGHTING – CANNOT BE TOTALLY
RESET TO FACTORY SETTINGS WHILE
DRIVING!
.