Marantz SR6003 - Manual (Page 74)

71
ENGLISH
BASIC
CONNECTIONS
BASIC OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
ADV
ANCED
OPERA
TION
MACRO MODE
PROGRAMMING MACROS
Macros make it possible to use a single function button
to perform more complex series of operations that
would normally require pressing several buttons.
A single MACRO can be programmed to perform up
to 10 steps in sequence.
A typical example of such a series might be as
follows:
• Turn this unit’s power on
↓
• Switch this unit's input source to DVD
↓
• Turn the TV’s power on
↓
• Set the DVD player to play.
• No signals may be transmitted during macro
programming.
• The various steps that make up a macro are
set initially to be sent one after another in 1
second intervals, however these intervals may be
shortened to as little as 0.5 seconds or lengthened
to as much as 5 seconds using the setup mode.
• In the macro mode, the number of steps the macro
is displayed with Macro list number.
• Macros may be programmed 6 list.
MACRO button + numeric button (Example :
Macro list No.1 → MACRO button + “1”)
0 Program method of MACRO
1.
3.
1.
4.
3.
2.
1. Press and hold the SET and MACRO button
until the LEARN, MACRO indicators and
MACRO are displayed blinking on the LCD.
2. Press the numeric button for which you wish to
program a series of operations.
Press the 1 button.
• “M1-01” is displayed on the LCD.
• If selected macro number has already been
set the program, the LCD will blink.
3. Press the function buttons and command
button for the operations you wish to program
as a macro in the sequence.
For example, press DVD button and PLAY
button.
Press DVD Button (DVD Function)
↓
Press PLAY Button (Fixed 1st step)
• The number of steps in the macro is displayed on
LCD and this number increases by 1 with each
button pressed.
• Each macro number can be programmed to
perform up to 10 steps in sequence.
Note:
When programing the amplifi er's input source in the
macro program, fi rst press the AMP button, and press
the source button.
(In the case of DVD input: AMP
→ DVD)
4. When you are fi nished programming macros,
press and hold the ENTER button until the
display returns to normal mode (Turn off the
LEARN and MACRO indicators) .
• In the macro mode, it is possible to program
the memory to perform macros containing
up to 10 steps.
• Macros cannot be programmed for the
MEMO, cursor, ENTER, VOLUME+/- and
CL buttons.
Note:
If, while programming, no buttons are pressed for
approximately 1 minute, the remote controller will
automatically return to normal mode, and no macro
will be programmed in the memory.
CONFIRMING MACROS
Macros may be confir med using following
procedure.
1.
1.
5.
3.
2.
1. Press and hold the MACRO and MENU
buttons until the LEARN, MACRO indicators
and MACRO are displayed blinking on the
LCD.
2. Press the numeric button to be confi rmed.
Let’s use the example of macro number 1, by
pressing “1” button.
• LEARN, MACRO indicators and M1-01 are
displayed blinking.
3. Press the VOLUME button.
• M 1 - 0 1 i s d i s p l aye d a n d L E A R N i s
disappeared.
• The programmed operation is transmitting.