Marantz SR6003 - Manual (Page 20)

ENGLISH
17
BASIC
CONNECTIONS
BASIC OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
BASIC OPERA
TION
(Using the remote controller)
1. To select tuner, Press the TUNE button twice
within two second on the remote controller.
2. Press the BAND button to select either FM or
AM.
3. Press and hold the TUNE 3 or 4 button for 1
second or more.
4. Automatic searching begins then stops when a
station is tuned in.
If tuning does not stop at the desired station, use to
the “Manual tuning” operation.
MANUAL TUNING
1. 2. 3.
1.
3.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select either FM or
AM.
3. Press the 3 or 4 cursor buttons on the front
Panel to select the desired station.
(Using the remote controller)
1. To select tuner, press the TUNE button twice
within two seconds on the remote controller.
2. Press the BAND button to select either FM or
AM.
3. Press the TUNE 3 or 4 button to tune in the
deseired station.
DIRECT FREQUENCY CALL
1.
2.
4.
3
1. To select tuner, Press the TUNE button twice
within two seconds on the remote controller.
2. Press the BAND button to select either FM or
AM.
3. Press the F.DIRECT on the remote controller,
display will show “FREQ----”.
4. lnput your desired station’s, frequency with the
ten numbered keypad on the remote controller.
5. The desired station will automatically be tuned.
(FM) TUNING MODE (AUTO STEREO OR MONO)
When in the auto stereo mode, “AUTO” indicator will
be illuminated on the display.
The “ST” indicator is illuminated when a stereo
broadcast is tuned in.
At open frequencies, the noise is muted and the
“TUNED” and “ST” indicators are not illuminated.
If the signal is weak, it may be diffi cult to tune into the
station in stereo. In such a case, Press the T-MODE
button on the front panel or T.MODE button on the
remote controller.
“AUTO” indicator is not illuminated, if FM stereo
broadcasts are received in monaural and the “ST”
indicator is not illuminated.
To return to auto stereo mode, Press the T-MODE
button on the front panel or T.MODE button on
the remote controller again. “AUTO” indicator is
illuminated the display.