MITSUBISHI ELECTRIC CP900E - Manual (Page 49)

49
CONNECTIONS
PRINTING
PRECAUTIONS
FEA
TURES
PREP
ARA
TION
OTHERS
TROUBLE- SHOOTING
ADJUSTMENTS
INPUT Input signal setting display
• Set this menu before memorizing image.
FIELD The odd and even field lines will be reversed depending on the
input interlaced signal. Printing image is not clear so that the odd
and even field lines may be reversed depending on the input
interlaced signal. In this case, FIELD is set to “REV”. (The image
disorder cannot be seen in monitor display.)
NOR(Normal) Does not reverse FIELD as remaining the input interlaced signal.
REV(Reverse) Reverses the even and odd numbers of FIELD.
AFC (Automatic frequency control)
The image distortion on the top may occur when the VCR image is
special input such as in pause, field-by-field playback, or FF playback
mode. Also, the image is not printed correctly because of a weak TV
signal. In this case, set the AFC function to “ON”.
• The image distortion on the top may occur by the special signal when AFC is
set to “ON”. In this case, set to “OFF”.
• This function menu is invalid when selecting “FRONT” on H-START of MEMORY
POSITION in MAIN MENU.
OFF AFC is invalid.
ON AFC is available.
AGC (Automatic gain control)
This function is to automatically adjust a dark picture in brightness
and print with sharp contrast. Peak level of an input signal is detected
and signal width is standardized to the appropriate value.
OFF AGC is invalid.
ON AGC is available.
• This function is not displayed when selecting RGB signal.
DCF This function selects whether separating the composite video signal
or not. When inputting the monochrome signal, set this function to
OFF. Input signal is not through DCF circuit, so that this function is
for high quality of monochrome image. When inputting the colour
composite signal, this function is set to “ON”. Input signal is
through DCF circuit and the composite video signal is separated.
OFF When inputting monochrome signal
ON When inputting colour signal
• This function is not available when selecting RGB or S-VIDEO.
IN SYNC Selects the level of input sync.signal.
TTL Composite Sync.of TTL level
SOG Composite Sync.on Green
0.3V Composite Sync.of 0.3Vp-p level
INPUT
FIELD NOR/REV
AFC OFF/ON
AGC OFF/ON
DCF OFF/ON
IN SYNC TTL/SOG/0.3V