Gateway DC-M50 User Manual

Page 163

163

Solution

Rotate the function dial to and slide the power
switch to turn on the camera.
Replace all four batteries.

Remove the batteries and then insert the batteries by
following the +/- diagram indicated on the front of the
battery-chamber door.
When "NO CARD" is displayed on the LCD monitor and
"CF" is displayed on the data panel, the CF card is not
set. Insert the CF card.
Slide the power switch to turn on the camera again.

The camera reads out the image data from the CF
card.
Wait until the reading is completed and the focus lamp
and "PLAY BACK" stop blinking.
Take a picture within the flash range ( 15 to 118 inches)
( 40 to 300 cm ).

Problem

The image
cannot be
played
back on
the LCD
monitor.

The image
recorded in
the flash
mode is
dark.

Check

Is the camera turned off?

Are the batteries exhausted?

Are the batteries inserted with the
correct polarity?

Is the CF card inserted in the
camera? ( Is "NO CARD"
displayed on the LCD monitor? )
The auto power off function
activates.
Is the focus lamp ( green )
blinking slowly (about 2 times in
a second ) and "PLAY BACK"
blinking on the LCD monitor?
Did you take a picture within
the flash range?

Page
80