Grizzly Extren Series Jointer g9860 - Manual (Page 20)

-18-
Extreme series Jointer (Mfg. since 9/11)
3. align the keyway underneath the fence sup-
port key (see Figure 19), then place the
fence assembly on top of the support.
Figure 19. Fence support key.
Fence support Key
4. slide the flat washer onto the fence lock
shaft, insert the shaft into the hole on the top
of the fence assembly and through the slot of
the support.
Figure 20. installing the fence lock.
Fence lock
t-slot Nut
Installing Fence (G9953/G9953ZX/
G9953ZXF)
1. remove the six pre-installed cap screws and
lock washers on either side of the fence base
support (see
Figure 21).
2. With assistance, place the fence assembly
onto the fence base support.
Figure 21. Fence assembly installed.
Fence Mounting Cap
screws (3 of 6)
Fence assembly
Fence
Base
support
3. secure the fence assembly with the six
cap screws and lock washers removed in
Step 1.
5. to secure the fence assembly, thread the
t-slot nut onto the bottom of the lock shaft so
that nut fits up into the slot of the fence sup-
port, as shown in
Figure 20.
Figure 18. installing the fence support.
Fence support
Installing Fence (G9860/G960ZX)
1. remove the motor access panel on the back
of the machine.
2. remove the cap screws and lock wash-
ers that are pre-installed on the bottom of
the fence support, then, with assistance,
secure the support to the jointer with these
cap screws and lock washers, as shown in
Figure 18.