Grizzly G0444 - Manual (Page 40)

-38- G0444/G0444Z 10" Table Saw
Always be aware of the condition of your
machine. Routinely check the condition of the fol-
lowing items and repair or replace as necessary:
• Mounting bolts
• Power switch
• Saw blade
• Blade guard
Always disconnect
power to the machine
before performing main-
tenance. Failure to do
this may result in serious
personal injury.
!
Clean the Model G0444/G0444Z according to the
schedule below to ensure maximum perfor-
mance. Note—
The following maintenance sched-
ule assumes the saw is being used every day.
Daily:
• Wipe down the table surface and grooves
with a rust preventive such as SLIPIT
®
(Grizzly items G5562 & G5563).
• Clean the pitch and resin from the saw blade
with OxiSolv
® Blade & Bit Cleaner (Grizzly
item G1955).
Weekly:
• Clean the motor housing with compressed
air.
• Wipe down the fence rails with a dry silicon
lubricant such as Spraway
® Silicon Lubricant
(Grizzly item G2545).
Lubricate the areas indicated below every 12
months.
1. Blade angling trunnions . These should be
lubricated with 6 or 7 drops of light machine
oil.
2. Blade height trunnion . This should also be
lubricated with 6 or 7 drops of light machine
oil.
3. The 2 worm gears should be lubricated with
an automotive wheel bearing grease.
These points can be reached from the back of the
machine. Check all adjustments after lubricating.
Miscellaneous
Lubrication
Cleaning
SECTION 7: MAINTENANCE