Motor – Grizzly G0444 User Manual
Page 23
G0444/G0444Z 10" Table Saw
-21-
Motor
Components and Hardware Needed:
Qty
Motor ..................................................................1
Motor Plate ........................................................1
Motor Bracket ....................................................1
Motor Bracket Shaft............................................1
V-Belt Plate ........................................................1
V-Belt Guard ......................................................1
Hex Bolts
5
⁄
16
"-18 x 1 ........................................4
Hex Nuts
5
⁄
16
"-18 ................................................4
Flat Washers
5
⁄
16
" ..............................................8
Lock Washers
5
⁄
16
" ............................................4
Carriage Bolt
1
⁄
4
"-20 x 1
3
⁄
4
" ................................1
Brass Wing Nut
1
⁄
4
"-20 ......................................1
Speed Nut
1
⁄
4
" ....................................................1
Tools Needed:
12mm Wrench or Socket ....................................1
10mm Wrench or Socket ....................................1
4mm Allen Wrench ............................................1
To install the motor:
1.
Using a 12mm wrench, loosely secure the
motor to the motor plate with the hex bolts,
the lock washers, the flat washers, and the
hex nuts (
Figure 18)
.
Figure 18.
Installed motor plate.
Motor Plate
2.
Slide the carriage bolt through the hole in the
V-belt plate and slide the speed nut over the
carriage bolt end.
3.
Slide the v-belt plate between the motor and
the motor plate and over the hex bolts
(
Figure 19
).
4.
Finger tighten the fasteners that secure the
motor to the motor plate.
5.
Secure the motor plate to the motor bracket
with the motor bracket shaft (
Figure 20
).
Note—
The hex bolt on the motor bracket
must align with the groove on the motor
bracket shaft.
Figure 19.
Installed V-belt plate.
Figure 20.
Installed motor bracket.
Motor Bracket
Motor Bracket Shaft
V-Belt Plate