GE ZET2R - Manual (Page 46)

46
To clean
the door Inside of the door:
• Because the area inside the gasket is cleaned
during the self-clean cycle, you do not need to
clean this by hand. Any soap left on the liner
causes additional stains when the oven is
heated, so be sure to rinse thoroughly.
• The area outside the gasket can be cleaned
with a soap-filled scouring pad.
• Do not rub or clean the door gasket—
the fiberglass material of the gasket has an
extremely low resistance to abrasion. An intact
and well-fitting oven door gasket is essential
for energy-efficient oven operation and good
baking results. If you notice the gasket
becoming worn, frayed or damaged in
any way or if it has become displaced on
the oven, you should have it replaced.
Outside of the door:
• Depending on your model, see the Stainless
steel surfaces section or the Painted surfaces
section.
Care and Cleaning
Wall Oven
Painted surfaces include the door, top
of the control panel and the drawer front.
Clean these with soap and water or a vinegar
and water solution. Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface. Painted
surfaces
(on some
models)
Do not use a steel-wool pad; it will scratch the
surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number, 800.626.2002 or visit
monogram.com. Stainless steel
surfaces (on
some models)
It’s a good idea to wipe the control panel after
each use. Clean with mild soap and water or
vinegar and water, rinse with clean water and
polish dry with a soft cloth. When cleaning,
the control panel should be at room
temperature and not in direct sunlight.
Use of other liquid cleaners is not
recommended – the residue they
leave behind may affect the control. Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven cleaners
on the control panel—they will damage
the finish.
A 50/50 solution of vinegar and hot water
works best.
Control panel