Grizzly Slip Roll 16 Gauge G5771 - Manual (Page 22)

-20-
g5771 50" slip roll 16 gauge
figure 31. Releasing upper roller.
3. With the help of an assistant, slide and lift the
upper roller out from the base. remove the
workpiece from the upper roller, then place
the upper roller back onto the base (
figure
31).
4. Move the upper roller back into position and
slide the removable bushing in to secure the
upper roller (
figure 32).
figure 32. Securing upper roller.
5. Center the roller at the gearbox end and
thread the hex bolt back into the upper roller
bushing. then, tighten the jam nut against
the base to lock the hex bolt in place.
Removing Workpiece
to remove cylindrical workpieces:
1. loosen the hex bolt and jam nut that secure
the upper roller at the gearbox ( figure 29).
2. slide the removable bushing outward. this
will release the upper roller from the stand
(
figure 30). do not yet attempt to remove the
upper roller.
the components of this machine
are very heavy and workpieces can be
cumbersome and have sharp edges. Always
wear gloves and fully support components
and workpieces. Get help if necessary.
failure to do this may result in personal
injury.
figure 29. Hex bolt and jam nut.
figure 30. Removable bushing release.
upper roller
Bushing Bolt
Jam nut
removable Bushing
removable Bushing
released
secured